IMD600 "RESERVOIR" MOLD

Before you buy this mold on-line please notice that free shipping apply only if you buy it as an addition to other molds . If you need only this design please purchase it via e-mail. When placing order via e-mail, please don't forget to send me your mailing address.

Retail: $5.90

Special offer: $2.95
TO PLACE AN ORDER VIA E-MAIL

Largest problem with pouring solid tiles was small pour-holes. Ceramist had to keep adding slip every minute or so. I manage to solve this problem with "Reservoir" molds IMD-600. They allow you to keep an access of slip over pour-holes, so you don't have to add more slip every minute. If you tried to pour tile or plate mold with closed bottom (it does make a very nice back side) then you are familiar with that problem. You have to keep mold full all the time to prevent it from trapping air inside. And what a task it is. With a "reservoir" mold you simply place it over pour-halls and you wouldn't have to worry about adding your slip again. Simply place them over pour-holes and 15 min. later just slide them off.